monkey 新手问题。。。线面交点怎么求？？

552zxp64

一个面与一个curve 求交点 是哪个命令？
试了半天CurveBrepIntersect总是说我类型不对啊啊啊。。。

人子

做标记做标记做标记做标记做标记做标记做标记

夜神

如果要大量的做线面求交，且不在乎交点的精度，建议把曲面离散成mesh，然后抽出每个三角面片的顶点，再用几何算法计算交点。这种算法的速度比CurveSurfaceIntersection能提高差不多1~2个数量级。

p.s. 希望你的中学数学还没忘光

tony_tsang

我看了help可以直接用。
Sub CSX()

Const rhObjectCurve = 4

Const rhObjectSurface = 8

Dim strCurve, strSurface, arrCSX

strCurve = Rhino.GetObject("Select curve", rhObjectCurve)

If IsNull(strCurve) Or Rhino.IsCurve(strCurve) = False Then Exit Sub

strSurface = Rhino.GetObject("Select surface", rhObjectSurface)

If IsNull(strSurface) Or Rhino.IsSurface(strSurface) = False Then Exit Sub

arrCSX = Rhino.CurveSurfaceIntersection(strCurve, strSurface)

If Not IsArray(arrCSX) Then

Rhino.Print "Curve and surface do not intersect."

Exit Sub

End If

For i = 0 To UBound(arrCSX)

If arrCSX(i,0) = 1 Then

Rhino.Print "Point"

Rhino.Print "Intersection point on curve: " & Rhino.Pt2Str(arrCSX(i,1))

Rhino.Print "Intersection point on surface: " & Rhino.Pt2Str(arrCSX(i,3))

Rhino.Print "Curve parameter: " & CStr(arrCSX(i,5))

Rhino.Print "Surface parameter: " & CStr(arrCSX(i,7)) & "," & CStr(arrCSX(i,8))

Else

Rhino.Print "Overlap"

Rhino.Print "Intersection start point on curve: " & Rhino.Pt2Str(arrCSX(i,1))

Rhino.Print "Intersection end point on curve: " & Rhino.Pt2Str(arrCSX(i,2))

Rhino.Print "Intersection start point on surface: " & Rhino.Pt2Str(arrCSX(i,3))

Rhino.Print "Intersection end point on surface: " & Rhino.Pt2Str(arrCSX(i,4))

Rhino.Print "Curve parameter range: " & CStr(arrCSX(i,5)) & " to " & CStr(arrCSX(i,6))

Rhino.Print "Surface parameter range: " & CStr(arrCSX(i,7)) & "," & CStr(arrCSX(i,8)) & " to " &  CStr(arrCSX(i,9)) & "," & CStr(arrCSX(i,10))

End If

Next

End Sub

Tony

同意3楼...

qiqiyunyan

也是初学，所以不懂

tgbyhnbgt

曲线-物件交集

xdyang

楼主可以试试CurveSurfaceIntersection命令

richo

没有研究过，等待高人解答